King...
SE-251 Cam??? Going by memory, isnt the the SE-251 cam a .579" lift? Aren't the stock heads on the FLHTCSE(2) only capable of a .575" lift? Have you changed the heads? Was the tolerance close enough to give it a whirl? Was the improvement over the stock SE-253 cams worth it? Lots of Qs, but if it was worth it, I'll drop mine off at the shop next week!
I love the SE-251 cams. I put them in the last bike I built (95" & HTCCs). I havent done so, because I didn't feel like spending the $$$ on heads, etc...
Your signature doesn't list different heads.
Please advise.
yes, i have the 251 cams.
i have the stock heads. i changed out the springs to accomodate the high lift.
i had them check all of the clearances and tolerances.
if i am not mistaken the stock heads only accomodate a 565 lift.
the cam was recommended by the dealer beacause of the long exhaust.
i am happy with the change.
the torque comes in much earlier now.
i had a dyno sheet posted, but it got lost when there were problems with the site.
i have had it dynod since, but i cannot find the sheet.
here is an older one. i was not to happy with the tuner.he did not have the air fuel sniffer and tuned it by seat of the pants.
sinc i had it retuned, the max torque is about the same, but it is a much smoother graph.
i am happy with the cam. it was worth the money.