Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: How to wire in 660 garmin  (Read 972 times)

0 Members and 1 Guest are viewing this topic.

bubtrauma

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 951
How to wire in 660 garmin
« on: May 21, 2012, 04:54:21 PM »

Hi guys how did you wire in your 660. I am thinking the audio out could go to the aux port on radio

bob
Logged
bend it, chop it, cut it, bang it, weld it and paint it to match........

bissjim

  • Vendor
  • Elite CVO Member
  • *
  • Offline Offline
  • Posts: 731
Re: How to wire in 660 garmin
« Reply #1 on: May 22, 2012, 06:31:57 AM »

You are correct. The Audio Output from the Garmin goes to the AUX input. You will need a 3.5mm Male Stereo to 3.5mm Male Stereo cable such as the one below. The Right Angle makes for a neat install. You can pick up power from the cigarette lighter and if you want to make and take phone calls you will need an H-D Bomm (www.hdbomm.com) helmet to GPS microphone interface or similar.

http://www.amazon.com/Hosa-Stereo-Angled-3-5mm-Cable/dp/B001JYLV54

Jim
Logged
Ride It Like You Are Retired

Fire-Medic

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 146
  • Bad Monkey

    • CVO1: 2012 CVO RGC "Dirty Skunk"
Re: How to wire in 660 garmin
« Reply #2 on: June 07, 2012, 03:35:18 PM »

Is there a power cable for the Road Tech 660 that does not have all the extra ports on it, just to get power to the unit?

I bought a RT 660 and was planning to run the power cable in the handlebars, but there's too much junk on the power cable I have. I do not want all the extra's just power to the unit.

Thanks
FM
Logged

bissjim

  • Vendor
  • Elite CVO Member
  • *
  • Offline Offline
  • Posts: 731
Re: How to wire in 660 garmin
« Reply #3 on: June 08, 2012, 07:21:13 AM »

I spoke with you on the phone yesterday about this. If you are still confused give me a call.

Jim
Logged
Ride It Like You Are Retired

Fire-Medic

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 146
  • Bad Monkey

    • CVO1: 2012 CVO RGC "Dirty Skunk"
Re: How to wire in 660 garmin
« Reply #4 on: June 08, 2012, 10:48:25 AM »

I spoke with you on the phone yesterday about this. If you are still confused give me a call.

Jim

Yes we spoke after I posted, thanks for your time.

I decided to forgo the idea for the time being.

Logged
 

Page created in 0.126 seconds with 21 queries.