Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[CVOBreak]

Does anyone know how to show the DTC codes on the Breakout?
My local Harley dealer said "we have to plug it in to our computes because we don't know how to get the codes to show on the speedometer"

How pathetic is that?

[Z06_Pilot]

hmmmmm.

If you have a fuel manager, some of them display the codes for you(I know the PowerVision does-it's pretty cool because it gives you the code AND an english language explanation of what it is....).

I know how to get codes on a V-Rod, but it involves using the ignition switch, which we don't have on the Breakout......

[CVOBreak]

The PV is giving a useless code "odometer learned up" no one knows what it means??

[Big-Aye]

Does anyone know how to show the DTC codes on the Breakout?

It's under Odometer Self-Diagnostics in the FXSBSE Service Manual Supplement [99494-13] starting on page 7-22:

"1. To enter diagnostic mode, press and hold the trip odometer reset switch located on the left handlebar controls, while turning the engine stop switch ON."

"2. Release the trip odometer reset switch. 'diag' will appear on the odometer display."

"3. Press and release the trip odometer reset switch. 'ECM' will appear on the odometer display. It will have either a "Y" or an "N" after it, depending on if there are any ECM codes or not."

"4. Quickly press and release the trip odometer reset switch to cycle through the modules. The modules include BCM, SPDO, and ABS."

"5. Once the desired module is displayed, press and hold the trip odometer reset switch."

"6. If any DTCs are stored in the module, the odometer will display the DTC. Quickly pressing and releasing the the trip odometer reset switch will cycle through the stored DTCs."

"7. When all the DTCs have been cycled the odometer will display 'end'."

"8. To clear all the DTCs in that module press and hold the trip odometer reset switch, while a DTC is displayed. If DTCs are not to be cleared quickly press and release the trip odometer reset switch. The part number of the module will be displayed."

"9. Press and release the trip odometer reset switch again to continue to the next module."

"10. Make note of all DTCs. Clear all the DTCs and operate the vehicle to verify DTCs set and are current. Historic DTCs are not to be diagnosed unless the condition is recurring and intermittent."

"11. Turn the engine stop switch OFF to exit diagnostic mode. If the engine stop switch is not turned off, vehicle will exit diagnostics mode when vehicle starts moving."

If your CAN-bus is messed up then the Odometer Self-Diagnostics won't work.
Historic DTCs will be cleared after 20 ignition cycles unless the error recurs.

DTC=Diagnostic Trouble Code
ECM=Electronic Control Module [monitors the engine sensors and signals the engine to start, idle, and run]
BCM=Body Control Module [supplies ignition and accessory power, including lighting]
SPDO=Speedometer
ABS=Anti-lock Braking System

Hope this helps...