Topic: Breakout New Chopped Fender Edge Light Kit (Read 13445 times)

CUZCO · « **Reply #15 on:** September 14, 2013, 03:29:30 PM »

Here it is.

cambo · « **Reply #16 on:** September 14, 2013, 03:34:40 PM »

Looks good. So you decided against using the reflector that comes with the kit?

CUZCO · « **Reply #17 on:** September 14, 2013, 05:59:32 PM »

I didn't want the extra reflector. Right now I am unable to figure how to wire it in. The connectors that came with it are for a Sportster and will not mate up to the Breakout connectors. I am trying out how to direct wire it in but can't figure out which of the turn signal wires to use. There are 3 wires going to each turn signal, Black Blue and Purple. I would have thought there would be 4, running, brake, turn and ground. I am not sure which wires work the running and brake.

cambo · « **Reply #18 on:** September 14, 2013, 06:16:59 PM »

On the breakout the dedicated brake light wire is attached to the connector for the license plate light. It is yellow and red and is open since the license plate does not have a brake light on the breakout. The license plate delphi connector is a three pin delphi connector next to the gray right turn signal delphi connector.

CUZCO · « **Reply #19 on:** September 14, 2013, 10:32:35 PM »

I do see the tag light, but it only has two wires, ground and power I assume. I am not sure as to what you are saying, exactly which wires should I splice the 3 fender light wires in to??

cambo · « **Reply #20 on:** September 14, 2013, 10:45:45 PM »

Check out the female connector with the wires coming from the battery. The yellow and red wire comes from the battery and connects to the middle pin on the female delphi connector. Nor the male side, which is connected to the license plate, there is a red plastic pin and no wires going back to the license plate led's. That's the break light. You can take the power from that connection since it has the running light voltage (which powers the license plate led's) and the break light (the middle pin).