Topic: Stock 110 engine modifications to HD SE stage III (Read 10412 times)

FlaHeatWave · « **Reply #30 on:** November 13, 2013, 03:50:14 PM »

Quote from: Steve Cole on November 13, 2013, 11:29:10 AM

Same dyno, run by the same operator (me), conditions were close to identical, since nothing is perfect. The dyno calculate corrections for SAE was 1.00 for tests and run conditions for the engines were the same. To me numbers are what they are I really do not care. The dyno is just one of many tools we use to be able to get a baseline starting point and a finishing point. Then numbers themselves do not matter, if it starts at 10 and goes to 12 then we went up. Our concern is that we must be able to do the same test over again at a later time and get the same results. Without being able to do that the time and effort is wasted.

Some GREAT posts here by SC!!!

This is what a lot of laymen (people?) don't understand about component development / dyno testing, and repeatability.

Most are just looking at the #s for bench racing bragging rights, because they (we) don't know any better...

Author Topic: Stock 110 engine modifications to HD SE stage III (Read 10412 times)

FlaHeatWave

Re: Stock 110 engine modifications to HD SE stage III