Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[cambo]

Cuzco could you also post a picture of the old reflector after removal? I am wondering what the thing looks like since I need to modify the metal piece. I am hoping you have the picture so I don't have to dig in there and take the reflector off before I am ready to tackle the project.

Thanks,

Cam

[CUZCO]

I will post up a couple of good pics this evening.

[CUZCO]

Bottom

[CUZCO]

Top

[CUZCO]

Edge that sits into the inner fender

[cambo]

Perfect!Thank you very much. I finally got all the parts I needed for the custom taillight. I will attempt to put everything together this weekend and post the results.

[CUZCO]

Good luck with it, can't wait to see it.

[Minigi]

Hi CUZCO,

I have a question about the turn signal on bike. What is a manufacturer? and where can I buy this?

thanks

Minigi

[CUZCO]

ChromeGlow.com

http://www.chromeglow.com/catalog.asp?prodid=771264&showprevnext=1

BE SURE TO ADD THE RUNNING LIGHT OPTION

Just last night I finally had the time to wire in the running lights, everything works perfectly, if the sun is out this weekend I will get some pictures of the light in the sunlight.

Also I would leave the reflector on as it will help hold the LED inplace. You must drop the inner fender support (the reflector is attached to it) stick on the LED strip then raise and tighten the fender support. The reflector will snug right up to the LED light and that way there is more than just tape holding it on.

[cambo]

Looks great. How about with it off? Would love to see what it looks like when the bike is just sitting there.

[CUZCO]

I will do that tonight, you really can not see it on there. I ordered the smoke gray and since it is right along the lip it just blends in.

[cambo]

Cool. That's what I needed to find out. I really like how it looks when lit up but did not want the cheap glued-on led strip look when the bike is just sitting there.

[Joec410]

How did you route the wires?  Did you run them between the fender support and the fender?  What did you use to hold them in place after the fender support?

[CUZCO]

I loosened the inner fender support so that it would drop down a bit, ran the wire in between the fender support and the fender. I also installed one wire hook with double sided tape between the front of the fender support and the front of the fender. On the front right side of the fender there is a small hole that I ran the wire through after installing a rubber grommet in the hole.