Topic: Just Installed TTS100 cams and Fullsac DX UPDATE (Read 13270 times)

North Star · « **Reply #30 on:** October 12, 2015, 04:01:25 PM »

I may have found the real reason for my issues.

I had a compression and leak down test done.

The front cylinder is at 170, and the rear is at 140. This was done with the ACR's disabled (fuse was pulled).

Not good for an engine that just had new cylinders, pistons, rings, valve guides, etc about 20,000 miles ago

Considering this, I'm lucky I even have the numbers/curve that I do.

I'm going to discuss with Dave what to do over the winter. Might as well take advantage of the dealer winter service specials. He suggested a Tman or Zippers package, but I think at this point I might just freshen up the top end, leave the TTS100 in, and do some kind of exhaust change and leave it at that.

Author Topic: Just Installed TTS100 cams and Fullsac DX UPDATE (Read 13270 times)

North Star

Re: Just Installed TTS100 cams and Fullsac DX UPDATE