www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Wiring harness for tour pack air wing luggage rack LED light.  (Read 3024 times)

0 Members and 2 Guests are viewing this topic.

deldago

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 640
    • OH


    • CVO1: 2013 FLTRXSE2
Wiring harness for tour pack air wing luggage rack LED light.
« on: May 05, 2018, 01:41:48 PM »
Can anyone shed some light on what splitter I need to get the brake light that is under the chrome luggage rack to work? I bought a tour pack from a fellow member and the harness that came with it only works the lights built into the tour pack not the little one under the luggage rack. When I look it up the light is part # 68271-08a with the smoked lens but the instructions say the harness is not sold separately. When I went to the local dealer the parts kid gave me part # 70683-08 which is for 14 and up sportster. Glad I didn't have him order it without checking as the TP lock he ordered to match my bike key was wrong also.
Logged
T-MAN 117 kit

ultrafxr

  • There are no sure answers, only better questions. - Dick Van Dyke
  • 5k CVO Member
  • ***
  • Offline Offline
  • Posts: 5477
  • No problem is so small it cannot be misunderstood.
    • TN


    • CVO1: 2020 FLHTCUTG Tahitian Teal
    • CVO2: 2017 FLHTKSE Palladium Silver/Phantom Blue/Wicked Sapphire-traded
    • CVO3: 2012 FLHTCUSE7 Electric Orange/Black Diamond-traded
Re: Wiring harness for tour pack air wing luggage rack LED light.
« Reply #1 on: May 05, 2018, 05:00:39 PM »
Look at item 14 on the instructions:

14.   
Locate and disconnect three pin AMP connector for Tour-Pak lights.

You can purchase the AMP connectors from your dealer and make your own Y-harness.  Or you can use a Posi Tap to tie in to the existing wiring.  Just match up the wire colors.
Logged



Places ridden on my bike from my driveway.
IBA member # 45520

GQ_Knuckle_Draggerz

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 84
  • www.CVOHARLEY.com
Re: Wiring harness for tour pack air wing luggage rack LED light.
« Reply #2 on: May 07, 2018, 05:46:35 PM »
Brad - sounds like you need to tap into the rear brake lights. There’s an access plug under rear fender or seat.  Might be bundled up or near side cover.  It Uses the smaller plug coming out of tour pak.  If not, I’m not sure of harness part number but your local dealer should have it handy.  Let me check around & see what I can find for u.




Sent from my iPhone using Tapatalk
Logged

CVODON

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 2421
    • FL

    • CVO1: 15 FLTRUSE
Re: Wiring harness for tour pack air wing luggage rack LED light.
« Reply #3 on: May 07, 2018, 07:20:59 PM »
I connected mine to the harness behind, or under, the rear seat at lower front of the tourpak. Been a couple years but seems like it was covered in the instructions pretty well. I do remember it only took a few minutes once I got the wires ran thru the tourpak rack tubing  itself and into the tourpak.
Logged

GQ_Knuckle_Draggerz

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 84
  • www.CVOHARLEY.com
Re: Wiring harness for tour pack air wing luggage rack LED light.
« Reply #4 on: May 07, 2018, 07:22:58 PM »

Light kit instructions


Sent from my iPhone using Tapatalk
Logged

Patrickrobs

  • Newbie
  • *
  • Offline Offline
  • Posts: 1
  • www.CVOHARLEY.com
    • CA

Re: Wiring harness for tour pack air wing luggage rack LED light.
« Reply #5 on: October 18, 2019, 08:41:31 AM »
Hi there I saw your reply to this thread,    my wire from the luggage rack wont reach the female end .. Theres like a good 3 inch gap.. Is there an extension for these?  Pls text if possible.  Thank you 9493575119
Logged
 

Page created in 0.227 seconds with 25 queries.