Topic: Help please for USA domestic wiring for rear lights and tail lamps (Read 980 times)

2014CVO · « **on:** July 05, 2025, 02:18:44 AM »

Hi, I’m converting my HDI rear lights back to original USA domestic setup. Can someone please post a photo of their USA domestic model 2014 CVO Breakout rear turn lights and rear tail lamp connections, including wiring into connectors. My photos are attached for current HDI setup. I’m just not sure how to connect the new domestic lights (wiring) to my connector. Would love to see the wires from lights to connector and connector to main harness for both rear lights and lamp. Cheers and very much appreciated…stop by anytime for free beers.

Thank you.

2014CVO · « **Reply #1 on:** July 05, 2025, 02:23:46 AM »

Current lamp and rear right turn connectors picture attached…May someone please show me USA domestic setup.

2014CVO · « **Reply #2 on:** July 05, 2025, 02:24:49 AM »

Current rear left turn connector picture attached…May someone please show me USA domestic setup.

2014CVO · « **Reply #3 on:** July 05, 2025, 02:30:48 AM »

These are the rear tail Harley sold me…I believe and hope they are USA domestic?

2014CVO · « **Reply #4 on:** July 05, 2025, 03:36:40 AM »

A couple of beers later, reviewing electrical diagrams and how to disconnect and connect new pins to Deutsche connectors and, by George, I think I’ve got it.

Tractor Bubba · « **Reply #5 on:** July 06, 2025, 12:22:39 AM »

Congratulations on getting it sorted out!
Good luck on your project.

2014CVO · « **Reply #6 on:** July 06, 2025, 03:45:49 AM »

Cheers Tractor Bubba. All installed except need pins to do final connections under the seat and install Custom Dynamics rear light inserts. Then off to the dealer to get BCM changed back to USA settings. Looking forward to seeing how the rear run/brake lights look which are stuck to the underside of the fender.

2014CVO · « **Reply #7 on:** **Yesterday** at 04:12:29 AM »

Wiring ready to go. Custom dynamic lights installed. Just waiting for deutsch connector pins to arrive. Thankfully I made some space under the seat, otherwise the CD stuff would not be able to fit. You would think they could make the controller smaller and tidy up the wiring so it’s not so bulky. Had to separate the wiring too so that it could go to left and right hand side of bike.

2014CVO · « **Reply #8 on:** **Today** at 03:31:38 AM »

Big difference between polishing and not polishing.

Author Topic: Help please for USA domestic wiring for rear lights and tail lamps (Read 980 times)

2014CVO

Help please for USA domestic wiring for rear lights and tail lamps

2014CVO

Re: Help please for USA domestic wiring for rear lights and tail lamps

2014CVO

Re: Help please for USA domestic wiring for rear lights and tail lamps

2014CVO

Re: Help please for USA domestic wiring for rear lights and tail lamps

2014CVO

Re: Help please for USA domestic wiring for rear lights and tail lamps

Tractor Bubba

Re: Help please for USA domestic wiring for rear lights and tail lamps

2014CVO

Re: Help please for USA domestic wiring for rear lights and tail lamps

2014CVO

Re: Help please for USA domestic wiring for rear lights and tail lamps

2014CVO

Re: Help please for USA domestic wiring for rear lights and tail lamps