We are going to powder coat the frame in a copper with black speckle hammer tone, with the tank and rear fender painted in "hot rod black" then I will have my buddy micky do the old school pin stripping on it. We are going to use a copper braid over all the lines and wiring, along with a brass water style cap for the fuel. The screw on style used for semi's?? Not sure if you have seen that but it will look that way. The handle bars are still up in the air they are just for moving the bike at this point. Headers will be hand made once we get to that point. Tank is a 3.5 gallon so range will be limited but really I think I am more limited than amount of fuel even with the great roads we have the bike will beat you up. We have 3 days in this so far and it is moving right along. I have to finish boring the cylinders for the new JE pistons and then I will complete the top end on the little evo. This evo should put out 90hp as I have built many using these same parts before. Weight wise the will be in the 390-425 lb range so that little engine will spool it up very fast and the 6th gear will be nice to cruise. We are working on the seat pan now as he is out there with the planishing hammer making a TON of noise. We are not really trying to have a certain look just using items we have and we will see how it looks once we get there if we dont like it toss it and make something else.Oil bag will be mounted on the left side verticle with some hand twisted steel. We plan on painting the oil tank to look like a old oil can. Not sure what brand yet but time will tell.