Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[y2khd]

Finished up the 575's yesterday.       I had the same results as Jim, the brake hose has plenty of length. I actually had to disconnect my clutch hose and untangle it from the way they had it routed under the fairing to gain some length there. All in all it was a fairly simple straightforward job.

John     

[Jim]

John, did you remove the clutch line from the plastic clamp on the right side of the yoke? My line seems a little tight. Also did you trim the rubber grommets that are at the lower inner fairing and around the bars for a better fit of lower inner fairing. Thanks


Jim

[y2khd]

Jim

   If I understand you correctly, Yes I did and moved it to the inside. There was also an issue with where it crossed in front of the neck it was through a loop in the front brake line. When it was turned to the left it was putting the brake line and the clutch line in a bind.

   As far as the grommets I just pushed back on the fairing piece and it compressed the rubber without trimming.  Looks just like it should.

John

[harleyman]

i have a question how about the electronic throtlle and also will it be possible to install those bars in a 2008flrrse4?

[y2khd]

HARLEYMAN

     These bars are designed specifically for the dressers I don't know how the fitment would be on your 2008flrrse4. But I do believe they make a bar specifically for your bike.

     The bars we used the 575's are notched on the throttle end to accept the electronic throttle and there is no problem installing it

John

[harleyman]

thanks for the info i will try to find out if there is  a a handle bar for my 08 se roaking thanks.