www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  
Pages: 1 [2]  All

Author Topic: Time to open the Batwing  (Read 9533 times)

0 Members and 1 Guest are viewing this topic.

hdbrad03

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 2097
  • FLHRSEI.ORG

    • CVO1: 2009 FLTRSE3 Yellow Pearl/Charcoal Slate
    • CVO2: FLHTCSE-Pumpkin
    • CVO3: FLTRI 06
Re: Time to open the Batwing
« Reply #15 on: August 21, 2009, 09:40:15 PM »
I applied Heat Demons to my FLTRSE3. Must have 7/8" inside diameter for the heat element and the TBW Sensor to fit. I drilled mine out but was not easy. I would suggest having a machine shop hone the bars. Must be enlarged all the way to the wiring hole.


 :bananarock: :bananarock:
      Brad
Logged
I was there.  Were you?

East Coast
New River Gorge (10, 15)
Rib Fest (10, 11, 14, 15)
Wild WV (16)
Maggie Valley (08, 09, 10, 11, 12, 13, 14, 15, 16, 17)

West Coast
Sedona, AZ (08)
Pala (10)
Santa Fe, NM (13)

tjstreetglide

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 389

    • CVO1: 2010flhxse
Re: Time to open the Batwing
« Reply #16 on: August 21, 2009, 10:31:40 PM »
Quote from: mjb765 on August 21, 2009, 09:10:01 PM
and how much was that???
I would imagine 250. wont know till I get down there to install the rest of my acc.
Logged
TJ

Pete

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 109
Re: Time to open the Batwing
« Reply #17 on: August 22, 2009, 09:16:07 PM »
One side is on backorder until early September.
Logged
Pages: 1 [2]  All
« previous next »
 

Page created in 0.213 seconds with 20 queries.