Hey Jim I saw in a old post that you wanted to change your bar to chubby 575 also. Did you get a change to make that mod? I did it to my 06 and changed all the internal wires with extension. I changed to clutch and throttle and idle cables just because I didn't like that stretch look of the cables. I would like to know if you have to do the same with clutch cable? switch and throttle wires also? Any help would save me a lot of headaches
Trey
Hi Trey.
Yes I fitted them to this bike too (if you check the photos, you can see them!) - I had them on my 07. On the 07, I had to replace the front brake line, and the throttle and idle cables. The clutch pipe was tight, but just OK. On the 09, there are no throttle or idle cables, the front brake line is fine (because it goes back to the ABS unit, and has plenty slack), and the clutch pipe (again, you can see it in the photos in this thread) is still tight, but just OK. The internal wiring is long enough. So, answer is, nothing to replace on the current models, but make sure the WO575 bars you get have the slotted end for the TBW. (Mine didn't, and while you can modify them, as I did, it's a pain to have to do that, when you can get the right bars in the first place!)
Jim