Encoding the Pager Receiver:
For 2006 and earlier -
1. Turn pager OFF.
2. Press and hold the button - With the FOB type pager, it's the D button in the middle. On the Belt version, it's that side button. You will see the lights, and it will vibrate. Continue to hold button until the lights start rotating in sequence.
3. Press the Security Sytem FOB once to arm the system. Wait a few seconds. If successful, the pager will beep 4 times.
4. To confirm, arm and disarm a couple of times waiting 15 seconds between attempts. If not, try these steps again.
For 2007 and newer -
1. Put bike ignition on OFF.
2. Turn pager OFF.
3. Press and hold the button - With the FOB type pager, it's the D button in the middle. On the Belt version, it's that side button. You will see the lights, and it will vibrate. Continue to hold button until the lights start rotating in sequence.
4. Quickly (within 5 seconds) turn the ignition switch to ON, then back OFF. Wait a few seconds. If successful, the pager will beep 4 times.
5. To confirm, arm and disarm a couple of times waiting 15 seconds betweeb attempts. If not, try these steps again.
Hope this helps.