Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[rw3673]

Just put Ride Time LEDS on my Ultra tour pack

[rw3673]

Thin strip lights in bag filler strips look like pinstripes when off

[rw3673]

on run

[rw3673]

on brake

[rw3673]

Also put the side marker light modulator on that turns markers into turn signals  Replaced the brake lights on tour pak with the led boards so now they are brake and turnsignals as well.  Stuff is not cheap, but man it is noticeable.  I had the strip brakelight on my stock leather tourpak and you could see that from a mile away.

[SIX38]

Nice Job!! If that don't get their attention, nothing will. I just ordered the same set up and by the looks of yours, I made the right choice. How difficult was the install, especially removing and reinstalling the rear lenses?
Thanks
Tom P.

[rw3673]

Not hard.  Heat up the lenses a bit with a hairdryer and push them out from behind once the bulb is out.  You might have to pry them a bit with a small screwdriver. They send you a small length of hard pvc tube to use as a push tool that fits in the bulb whole.  You might have to apply a bit of clear sealer into the the groove on the tourpack before you push the lenses back in.  They supply a small resistor to put in the brake wire to make the turn signal more distinctive(unless you ordered the three board circuit that hardwires in... I got the bulb socket one that powers the whole board) which I installed, but subsequently cut out because it dimmed the brake lights too much.   

[Chains]

Wow, that should get even a person with hardly any sights attention, nice job.

[SIX38]

Not hard.  Heat up the lenses a bit with a hairdryer and push them out from behind once the bulb is out.  You might have to pry them a bit with a small screwdriver. They send you a small length of hard pvc tube to use as a push tool that fits in the bulb whole.  You might have to apply a bit of clear sealer into the the groove on the tourpack before you push the lenses back in.  They supply a small resistor to put in the brake wire to make the turn signal more distinctive(unless you ordered the three board circuit that hardwires in... I got the bulb socket one that powers the whole board) which I installed, but subsequently cut out because it dimmed the brake lights too much.   

Thanks for the info rw3673. Looks like a nice project for next Saturday.

Tom P.