I bought a used FLHTCUSE3 and it came with the H-D Security System Pager Receiver II and was working. Battery died and I repalced it but I don't know how to marry it back to the bike. He didn't give me a manual for it. Also, if I change the Smart FOB battery, will does it automatically reconnect?
From the instruction manual..
2007 and Later Models (Hands Free FOB):1. Ensure that the motorcycle ignition switch is turned to the OFF position.
2. Ensure pager receiver is turned OFF.
3. Press and hold the pager receiver button (D). The pager receiver will flash and vibrate to indicate it is in the ON mode. Continue to hold the button until the LED indicators begin to flash one after another and the receiver begins to beep once every two seconds. The pager receiver is now in the encoding mode.
Note: The encoding mode will time out after beeping five times. If it times out repeat Steps 2 and 3.4. Quickly turn the motorcycle ignition switch to the ON position, then back to the OFF position. Within several seconds, the pager receiver will indicate that it has been successfully encoded by beeping four times.
5. To verify that the pager receiver has been successfully encoded disarm the security system by turning the motorcycle ignition switch to the ON position. Then quickly turn the ignition switch back to the OFF position to arm the security system. The left LED indicator (A) will begin to flash to indicate that it is receiving the Range Confirmation Signal (RCS). It may take up to 60 seconds for the indicator to begin flashing.
Ride Safe,
Fired00d
Author
Topic: Problem with pager receiver ll (Read 6334 times)