Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[DCFIREMANN]

HARRY the stock springs are not going to be used and the valve size was increased. I will have some pics tomorrow I hope as with some more info.

Be Safe

THE DAWG

[Unbalanced]

I know they changed the intake size, 2" intake / 1.625 exhaust"   Dan hadn't made a final decision yet on the springs as of 3 days ago and he wants me to swap the cam again.   I will be glad when they get delivered and I can give em a go.

See previous post from Specs from Dan.

Power kit 103

Total compression ratio is 10.0 to 1 using SE high compression pistons which require no second op work.

[kbiforce]

Baggerdad, you have a PM.

[RATMAN]

I'd like to see your dyno sheet when you get done.I will try to attach mine to this reply.Ratman

[nidan]

For a 103 look at Woods 400G

[DCFIREMANN]

For a 103 look at Woods 400G

Very good numbers, but what is the compression and what heads? I have had a set of these laying around for a while but there had been toooo much talk about valve train noise on other sites. So I ended up going in another direction.

Be Safe

THE DAWG

[nidan]

Good question , Bobby doesn't give many details , but has a great rep. While I didn't go with his cams , he was patient, courteous, very thorough and helpful when I was looking at cams.

[Steve_G]

I thought this thread was a question about a choice between two cams.  the TW26 or the TW37.  I haven't seen too much in the way of direct responses to this question.  Instead I see responses to all the different cams someone is using.  That's great, but should these type of responses be posted on a different thread?  -Steve

[kbiforce]

I posted my dyno sheet on the Eglide dyno numbers thread. I used the TW37 advanced four degrees.

[nidan]

Regarding the TW 26 - if using stock heads/compression it's a nice cam, good low end .

If using compression up to 9.8 and higher flow heads the TW37 will produce better power across the range.

If exceeding 9.8 and you want to stay with a similar cam , the TW31 will easily handle 10.5 same lift as the 37 , comes on lower (1800) .

I'm running a TW31G and love it.

I'd certainly consider other cam choices , talk with Andrews , Woods, and your wrench.