Thanks. And it does look nice. But......
I'm not sure the leak is fixed (dammit).
Or more accurately I'm not 100% sure I don't have a leak in a new spot. I know that during reassembly some oil dripped/settled/collected from the bottom of the case on to the top of the pan and the gasket. Wiped it off as well as I could but could not get at all of it. This was both engine oil and tranny oil.
After it's first run of 30 miles or so had oil on the side of the pan. Right side center. Not the old leak location. Much farther back. This is where most of the drippings had collected during reassembly. Snugged the bolts a bit after a heat and cool cycle from the one 30 mile or so ride and am hoping that the oil I saw was simply residue squished out during assembly. Been too busy to ride it much so won't get a chance to try it again until maybe tomorrow. Am keeping my finger crossed it either will now seal up ok or was only some residue squeezed out during reassembly.
But, yeah, it's pretty
.