Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Gamma742]

I purchased the Stage 1 Fullsac Kit that includes a TTS Mastertune with a MAP for my bike.

I am looking for the connector to flash the new MAP into the ECM.

I am following the instructions on page 16 of the TTS Mastertune Tuning Guide.

I'm here:
Plug the ECM programming cable into the bike’s diagnostic connector usually found under the side cover or seat.

Can someone that has this bike confirn the location of this connector. It is a common connector that looks just like the one that is used for the heated seat.

[Arctic John]

yes.  It should be attached to the front of the fuse box under the left side cover

[grc]

I don't think it's changed since 2008.  If that's correct, then it's under the left side cover as Arctic John mentioned.  See attachment.


Jerry

[SBB]

As always GRC is correct.
I took the left saddlebag and left side cover off the 2011.5 SEUC and took this picture.

SBB


click on picture to enlarge

[16HD117]

As always GRC is correct.
I took the left saddlebag and left side cover off the 2011.5 SEUC and took this picture.

SBB


click on picture to enlarge

I'm not believin' for a minute that you haven't already had that cover off to download another map! 

I think Otis has rubbed off on you!  "It's stock, I swear!"

 

[beechflyr]

SBB. Have you done anything regarding exhaust/ECM? TTS? Rev Performance still is not ready for 2011's.

[SBB]

SBB. Have you done anything regarding exhaust/ECM? TTS? Rev Performance still is not ready for 2011's.

beech, sent you a pm.

 

SBB

[mjb765]

SBB. Have you done anything regarding exhaust/ECM? TTS? Rev Performance still is not ready for 2011's.

Chip....I was thinking the same thing when I did not see the EMS module under that cover.....

[SBB]

Chip....I was thinking the same thing when I did not see the EMS module under that cover.....

Shhhhhhhhhhhh!

 

SBB

[Gamma742]

Thanks Guys..

I downloaded the factory configuration and saved it to my Laptop and uploaded the new MAP to the ECM and it runs like a whole different bike. I appreciate the help..

On a side note there is a connector under the seat next to the ECM that looked just like the correct one in the side cover, same dust cover and everything.

[kerb]

I don't think it's changed since 2008.  If that's correct, then it's under the left side cover as Arctic John mentioned.  See attachment.


Jerry

Does anyone know what site this picture is from?

[Midnight Rider]

Thanks Guys..

I downloaded the factory configuration and saved it to my Laptop and uploaded the new MAP to the ECM and it runs like a whole different bike. I appreciate the help..

On a side note there is a connector under the seat next to the ECM that looked just like the correct one in the side cover, same dust cover and everything.

That one is from the AUX switch on the dash...

[Twolanerider]

Had to look very close at this pic to see what was wrong inside Chip's side cover.  He's got gremlins in his fuse panel !

[mjb765]

Had to look very close at this pic to see what was wrong inside Chip's side cover.  He's got gremlins in his fuse panel !

You obviously have waaaay too much time on your hands.....

[Twolanerider]

You obviously have waaaay too much time on your hands.....

That pic of Dawg has been around waiting for a place to show up for two years or more.  When something like that happens you just have to make time.