Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Does anybody have the install instructions for....  (Read 999 times)

0 Members and 1 Guest are viewing this topic.

Ironhorse

  • Vendor
  • 2.5K CVO Member
  • *
  • Offline Offline
  • Posts: 4405
    • CA


    • CVO1: 2006 SE Ultra
    • CVO2: 2018 GoldWing DCT Airbag
Does anybody have the install instructions for....
« on: December 03, 2011, 08:00:27 PM »

HD Heated Grips? I am going to try wire them into another controller and need to check the schematics. It's my belief (which is probably wrong) the that failure lies within HDs controller and not the grips themselves. In other words the grips will work fine, it just that the controller craps out and that causes grip failure. The throttle grip is pretty easy, it's just two wires that connect to the controller. The clutch side is one that I need the schematic for. I'd like to see about by passing the controller wiring and seeing if I can make both grips work without it.

I am open to ideas and suggestions.
Logged
"But men are men, the best sometimes forget" Shakespeare, Othello Act 2, Scene 3

ThunderBueller

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 157
Logged
2010 FLTRX--Primo paint set
2005 FXSTB--Sold!
2003 XL1200C--Sold
2002 Buell S3T Thunderbolt--Sold


Wanted--black Rumble collection saddlebag latches.

 

Page created in 0.217 seconds with 24 queries.