www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Swapping the Volume & Scan up/down buttons  (Read 750 times)

0 Members and 1 Guest are viewing this topic.

dayne66

  • 2.5K CVO Member
  • **
  • Offline Offline
  • Posts: 4037
    • BC


    • CVO1: '12 Ruby/Typhoon SG
    • CVO2: '15 Superior Blue FLD Switchback
Swapping the Volume & Scan up/down buttons
« on: July 16, 2013, 10:04:33 AM »
The reason I'd like to do this is that my Jeep has the volume on the right.......and, with switching between the Jeep and Ruby, I'm continually using the wrong button. I think it can be done in  harness connector by swapping a few pins.
Logged
"The only true wisdom is in knowing you know nothing." Socrates

Coyote.

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 358

    • CVO1: 2007 SE Ultra - Buried in the back yard where it belongs.
    • CVO2: Already learned that lesson
Re: Swapping the Volume & Scan up/down buttons
« Reply #1 on: July 16, 2013, 10:18:21 AM »
You would need to swap all the functions as the Volume and Mode switches are setup as matrix switches.

It will be a little more difficult than just moving wires around from one connector to another as some of the wires used are shared with other switches and are Y'd inside the sheathing of the wire bundle going up the bars. But it could be done.
Logged
 

Page created in 0.11 seconds with 20 queries.