Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[gpopvet]

Just picked up 2014 CVO Road King and had the V&H Head pipe put on with stock mufflers and it is not loud enough, I do like the appearance but want it to sound louder, any help would be appreciated.

[FLSTFI Dave]

If you like the stock Look, Fullsac makes baffles you can install in your stock muffler cans.  1.75, 2.00 or 2.25 are the sizes and each is a bit louder as the size goes up.

If you want to get rid of the cat he makes two head pipes, a sport pipe and the DX, both go under the stock heat shields looks 100% stock, performs way better.

I have used this set up on 3 bikes for my wife, I have used it on four bikes for me, It's all ready on her 15 and my 15.

[harleychef2011]

You're probably gonna have to bite the bullet and put some new mufflers on.  I got the new V&H High Performance mufflers with the carbon tip (there is a thread in the exhaust section somewhere with a pic) and I'm loving them.  Did you get a dyno with the new head pipes?

[harleychef2011]

You're probably gonna have to bite the bullet and put some new mufflers on.  I got the new V&H High Performance mufflers with the carbon tip (there is a thread in the exhaust section somewhere with a pic) and I'm loving them.  Did you get a dyno with the new head pipes?

Here is the link thread:

http://www.cvoharley.com/smf/index.php?topic=97027.0

[jpdchicago]

I have the V& H Power Duals and Monster Rounds. Nice deep rumble, not too loud but great sound when you open the throttle.

[masiman]

Crusher mellows perform and sound good with the Vance and Hines head pipe.

[casbar]

Haven't changed my headers yet, but fitted slash cut ovals. Can you run V&H slash cut mufflers with True Dusls and Power Duals or will I be stuck with True Duals

[gpopvet]

How hard is it to change the baffles to Full sac?

[Joets185]

It wasn't difficult at all. Remove the stock tip. Grind down two spot welds. Pop the stock baffles out. Drill a 1/4 hole for the bolt to hold the new baffle in. Slide new baffle in. Install bolt and nut. Install tip. Good to go.

I also ordered the screens which allows you to cleanly use less of the packing material.

Joe

How hard is it to change the baffles to Full sac?