Made a route on my scenic drives. Just a 40 mile round trip back to house. Loaded fine onto thumb drive and into bike. Went to run it and it comes up fine until I try to "GO". It list the waypoints as "Turn left onto Rt 88" like its all directions. I only used waypoints, with no names when viewed on myscenicdrive, so the route wouldn't work. Even when I picked any one of the points from start to the last one turning on my street. Never gave any calculations or time of arrivals. I tried "calculate route" and "show route" all I would get a a quick "back" on the screen.
So I figure I screwed the planning up, and take a ride. Half way out I turn for home, hit "Home" and it lists my address, hit "go" and it flips to map but no route. SO I try again, same thing. Turn off radio, back on, same thing, turn off bike in lot, turn on, same, I get no routes. Select a "Previous" Sunoco. Nothing , just back to map.
Display shows me going on the road I am on, everythin g else looks good. Checked preferences, switched to twisty, same thing, back to "fastest" still no route.
Must have froze up something with my bad route. So I stop and delete it. Turn off and on, still no route.
How do I and should I factory reset?