Bout to install these bars on my wheel. Any tips from anyone would be greatly appreciated.
Jimmy
I installed my 12" Yafee's myself. The pointed turn on the Yafee's were The Devil. Yours should not be nearly, nearly as tough to get the wires through.
** Get a nice, little regular screw driver to get the pins out of the connectors. Basically you need them to push the little lock apart.
** Check the manual on how to properly disconnect the battery. If not you'll have your alarm going off. Mine would not shut up even with the battery disconnected.
** When you remove the ignition set DO NOT TURN IT. If you do there is a YouTube video with a guy who made a tool to fix it. Otherwise HD has the tool for sale.
** Not sure if you need to extend your wires. If so, be sure to offset the splices!
** Take your time! There's nothing really difficult installing your bars. I ended up using my wife's dish soap to get the wires to slide. But then again I was doing the pointed Yafee's.
** Take pictures through so you can see later how some of the things go back together. (Can you say connectors?)
Good Luck!