Well guys, I GOT IT FIXED!!!!
I wiggled the face plate and I could get a light, but no screen words etc.
Apparently I got a little too enthusiastic taking off my fairing to start working on the handlebars.
So I took the radio out and popped the face plate off. Under the face plate there is a 20 tab, or so, slide in connector between the face plate and the head unit.
The face plate had wires with little 45 degree bends in them right at the ends that would contact the flat tabs in the head unit. These tabs are probably .050" wide.
I took a very fine point tool and went behind each one and flexed them toward the center of the connector. I also had some fine abrasive stick that polish wiring terminals.
I put the face plate on while the radio was out and pulled over the rubber water sleeve and then plugged in the head unit. I fired up with a red screen light and the HD logo popped up and then I had all my normal screens.
So I dodged a bullet on this one, lesson learned.
While I was fooling around with the radio I noticed that my volt meter light was out. I changed out the bulb while it was exposed. So two birds with one stone as they say.
I want to thank everyone for the suggestions and concern about helping me out, greatly appreciated.
Have a great evening...