Topic: Khrome Works Bagger Ape Handlebar (Read 2961 times)

Devious · « **on:** August 11, 2017, 11:02:39 AM »

I ordered the Khrome Works 10 inch rise 1 inch bars 12 inch center width. Im a do it yourself kinda person and before I got into taking it apart I was wondering if anyone knew if I would need to get new brake and clutch cables. My bike has the clear plastic coated braided cables. Thank you

CVOSO · « **Reply #1 on:** September 06, 2017, 07:22:09 AM »

Hi Devious... I installed LA Chopper Twin Peaks Bagger Bars (10") and used the stock lines (hydraulic). I did mock things up before fully disassembling to see if there was enough line there. My biggest issue was re-running all the wires - recommend just taking time and making sure it is done right. Sorry I can't be of more help... Bear

Devious · « **Reply #2 on:** September 06, 2017, 11:44:37 AM »

Thanks for the info. I got it done. Once i got the fairing off there was plenty of slack. I probably could have gone higher if i wanted too. Thanks again

Lars · « **Reply #3 on:** September 07, 2017, 02:30:15 PM »

Glad the bars worked out for you.
I sure like the Khome Werks 12" Bobber Apes that I installed on mine.
Had to extend the wires but the brake and clutch lines were plenty long enough with minor rerouteing.

Devious · « **Reply #4 on:** September 07, 2017, 06:12:19 PM »

I didn't have to extend any wires. I cut a few zip ties under fairing and it worked out just fine. I'm going to take a pic tomorrow and post it here

Author Topic: Khrome Works Bagger Ape Handlebar (Read 2961 times)

Devious

Khrome Works Bagger Ape Handlebar

CVOSO

Re: Khrome Works Bagger Ape Handlebar

Devious

Re: Khrome Works Bagger Ape Handlebar

Lars

Re: Khrome Works Bagger Ape Handlebar

Devious

Re: Khrome Works Bagger Ape Handlebar