Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[skyglide]

Just looking at Kuryakyns web site and seen this in the new products section with lots of other new ideas.

[Twolanerider]

Sky, Kuryakyn released that license plate bracket and ring as a stand alone a few months back.  It looks ok installed to.  To complete the picture here's what it looks like on a fender:

[Twolanerider]

In profile:

[skyglide]

Sky, Kuryakyn released that license plate bracket and ring as a stand alone a few months back.  It looks ok installed to.  To complete the picture here's what it looks like on a fender:

Sorry Don I should have elaborated further on the original post. Its a new product that is one piece unit that has the fender extension like the FLHX Street Glide and the curved lic.plate mount. Comes with Red l.e.d. for the brake light or tail.
Just one more options for plate re locations. Should be released soon for $169.99

Hope this can help somone.

[skreminegul07]

Sky, Kuryakyn released that license plate bracket and ring as a stand alone a few months back.  It looks ok installed to.  To complete the picture here's what it looks like on a fender:

Twolane,
I am thinkink of the
kuryakyn curved license plate holder (3163) for the Street Glide for my 07SERK.  The light bar is the same and there is no chrome on the lower fender tip.  I know it will fit, but after downloading the install instructions from Kuryakyn (which is an excellent feature) I cannot determine if those four screws in the corner are real, and can you use them to remove the plate to add a sticker, etc.  The instructions have you slide the plate into the holder before bolting the assembly back onto the fender. 

Thanks

[Twolanerider]

Twolane,
I am thinkink of the
kuryakyn curved license plate holder (3163) for the Street Glide for my 07SERK.  The light bar is the same and there is no chrome on the lower fender tip.  I know it will fit, but after downloading the install instructions from Kuryakyn (which is an excellent feature) I cannot determine if those four screws in the corner are real, and can you use them to remove the plate to add a sticker, etc.  The instructions have you slide the plate into the holder before bolting the assembly back onto the fender. 

Thanks

Yes, functional screws.  The backplate/mounting bracket is all one piece.  Install it.  Then lay the plate and outer visible cover over the top of it and run those four screws in to hold them down.