Ok, took it to the HD shop today and after 1/2 hour inspection, they told me the oil gasket was missing that goes over the crankshaft. I said I don't remember putting one on because I installed a new inner primary housing which comes with main bearing and gasket seal. They said it doesn't come with a gasket seal. I said I feel silly, but an easy repair for me vs their $420 estimate. They said I wasn't the first to leave that gasket off. So I buy the inner primary gasket kit. I get home and disassemble primary and what do I find, a gasket seal in the inner primary housing. So one, HD was incorrect. Two, I may have found the cause of the leak, but not 100% sure. The pic attached shows the crankshaft and it appears, what I call an inner racer bushing over the crankshaft, has been pushed in about 1/2in or so. Far back enough to where the gasket doesn't seal the oil from leaking. If this is the case, how do I correct this??