Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Springer Risers  (Read 6306 times)

0 Members and 1 Guest are viewing this topic.

BIGMONEY

  • Newbie
  • *
  • Offline Offline
  • Posts: 1
  • www.CVOHARLEY.com
    • TN

Springer Risers
« on: October 08, 2023, 08:56:24 AM »

Looking for the shortest risers for my o7. will the risers from a crossbones work? or really any other springer Harley work? thanks
Logged

gmeikle

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 357
  • 2008 FXSTSSE2

    • CVO1: 2008 FXSTSSE2 Diamond Black
Re: Springer Risers
« Reply #1 on: October 08, 2023, 09:27:29 AM »

"Educated guess"...yes probably

I built a Crossbones front end into my 2008 CVO Springer and the component parts were often the same part number Crossbones V Springer

Slightly different rake on the Crossbones , but most all else the parts all worked. Had to make spacers for the axle as CVO Springer and Crossbones fenders differ.

I reused the CVO Springer headlamp, chrome risers and handlebars, alloy wheel, fender and fender mounting brackets. These were the "different" parts on the Crossbones.

I reckon the risers would fit/crossover. Assuming the handlebars are the same diameter , apologies I can't remember it was a few years back now.
Logged
No illegitimi carborundum

hogdownunder

  • AUSSIE SPRINGER
  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 99
  • 2008 CVO SPRINGER


    • CVO1: 2008 SCREAMIN EAGLE SPRINGER
    • CVO2: 2009 SCREAMIN EAGLE SPRINGER- SOLD
    • CVO3: 2007 SCREAMIN EAGLE SPRINGER
Re: Springer Risers
« Reply #2 on: October 17, 2023, 06:29:28 AM »

Hi guys,

The Cross bones handle bar is 1", the CVO handle bar is 1 1/4", therefore they would not fit.   
Logged

DarkEagle

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 109

    • CVO1: 2009 FXSTSSE3 Black Diamond with Emerald Ice Flames
Re: Springer Risers
« Reply #3 on: November 08, 2023, 02:46:51 PM »

Looking for the shortest risers for my o7. will the risers from a crossbones work? or really any other springer Harley work? thanks
The 2009 FXSTSSE3 riser stud is about an inch shorter than the 2007-2008’s.
I got the 2007-2008 riser studs to raise my 2009’s handlebars up a bit with no other mods, you could get the 2009 riser studs to lower yours but might have to watch clearance of the handlebars & handlebar mounted tach…
Sorry not responded sooner, don’t check this site as much, see diagram of the 2009 under HANDLEBAR, #9…
https://serviceinfo.harley-davidson.com/sip/content/document/view?id=1681729874893935931
« Last Edit: November 08, 2023, 02:48:49 PM by DarkEagle »
Logged
 

Page created in 0.23 seconds with 24 queries.