Topic: Jiffy Stand Extension (Read 1313 times)

bpalmersheim · « **on:** August 27, 2007, 10:41:53 PM »

Has anyone installed the Jiffy stand extension on a SERK? I'm short and definately could use it, any pics would be helpful. Thank!

Screamin' Al · « **Reply #1 on:** August 28, 2007, 03:57:02 AM »

I've fitted the jiffy stand extension (#50233-00) to my SERK. However, I found that if I followed the instructions to the letter, the position where the extension was supposed to be fitted onto the jiffy stand (around the existing rubber stop), resulted in the extension top being too close, when retracted, to the rear of the footboard. This meant that it would not have been easy to find the top of the extension with my boot. So I fitted it in the same position as I had on my Heritage Softail (hole centre approx 1" up from the fold line) and it works just fine. I did have to shorten the bolt a little as the bolt supplied expects the hole to be drilled through the thick weld on the stand.

Softail_Al

alejandro · « **Reply #2 on:** August 31, 2007, 04:31:01 AM »

i followed the instructions to a "t" and it works beautifully...

bpalmersheim · « **Reply #3 on:** August 31, 2007, 09:19:38 AM »

Quote from: alejandro on August 31, 2007, 04:31:01 AM

i followed the instructions to a "t" and it works beautifully...

Pics of jiffy stand up and down?

Author Topic: Jiffy Stand Extension (Read 1313 times)

bpalmersheim

Jiffy Stand Extension

Screamin' Al

Re: Jiffy Stand Extension

alejandro

Re: Jiffy Stand Extension

bpalmersheim

Re: Jiffy Stand Extension