Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Jock]

that was for Jock....

Got It...Thanks...

[Coolbreeze]

Me neither!  I've got spo's, and try  as I might, I just couldn't get 'em in any further!

[iski]

There's another way to tell there on wrong. The weld on the cone on the front of the muffler  should go to the inside.

Exactly. I have 2 seats of Rineharts & that's how I could tell the outside from inside.

[Capo]

My stealer is getting fed up with mr telling them mI found out about mstuff on the CVO sight-do you think they'll try and charge me to swap them around?

[ccr]

Yes

[Fired00d]

My stealer is getting fed up with mr telling them mI found out about mstuff on the CVO sight-do you think they'll try and charge me to swap them around?

They shouldn't since they were installed improperly. Take a look around and see if you can find a pair they installed properly and they don't have a leg to stand on. Good luck.

PS I'd also find out what tech installed them..... he might not be the tech you want working on your bike in the future.

 
Ride Safe,
Fired00d
 

[iski]

My stealer is getting fed up with mr telling them mI found out about mstuff on the CVO sight-do you think they'll try and charge me to swap them around?

Possibly.  If so I would speak to the Service Mgr.  If noi satisfactory response then the General manager or Owner.  If they all say an improperly installed part is something they are not responsible for correcting at no charge, I would strongly consider finding another dealer/shop for service.  Tech should have noticed the welds, IMHO.

[spydglide]

If nothing else, try to get a new set of clamps out of 'em......those clamps are recommended to not be re-used, and they're expensive.  spyder

[miker]

This thread had turned un-inspiring and will be ignored soon....Lets go people!

[Hugh Janis]

Thanks Mike!  For a couple days there I nearly felt inspired to go check the welds on my exhaust to make sure they were installed on the right side.  But, like a true CVO member, I fought it off.  From now on, I will endevour to persevere.

[iski]

Maybe this will inspire you to go look at those welds, George:

[Hugh Janis]

that works with my bike on the ground, do you have any inspiration for a bike on a lift?

[RJ749]

I'm going to guess Roger already knew that.

You loose, I never looked at the Nanner and obviously no one else did when I was buying it.

Looks like I got screwed.....probly never shudda bot it


click pic to enlarge

[iski]

that works with my bike on the ground, do you have any inspiration for a bike on a lift?

If this was in you4 garage, bet you would go look:

[Hugh Janis]

Those welds are PERFECT!