Chief, after seeing what you did to your SEUC2, I'm not worried, that of all people, you could figure out how to reengineer my oil cooler problem. Don;t worry I'm putting the whole process in your compentent hands.
Have been thinking about this way too much. Way too much. Last night pulled a stool up to the SERG setting on the lift and just looked at it. Then looked at it some more.
Popped the cooler loose to check out the bracketry and geometry of the mounting. A few sketches later and lots of simple options could be water jetted to mount it differently. Rerouting lines would be required of course. Probably no luck finding molded lines to fit. But it lines would not be unmanageable.
So go ahead AJ. You can make room around the oil cooler if that's all the problem

.