www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: SERK Engine Mount  (Read 869 times)

0 Members and 1 Guest are viewing this topic.

Sean M Cary

  • Guest
SERK Engine Mount
« on: July 21, 2008, 09:40:42 PM »
Is this a big issue?  As in- should I stop riding until I get it repaired?

Betting this gets d00d'd - but was not sure where to post it...

Sean
Logged

Sean M Cary

  • Guest
Re: SERK Engine Mount
« Reply #1 on: July 21, 2008, 09:41:16 PM »
another pic - had a hard time getting a good shot...

Sean
Logged

Boatman

  • 2.5K CVO Member
  • **
  • Offline Offline
  • Posts: 4816
  • FLHRSEI.ORG

    • CVO1: 2014 CVO Limited
    • CVO2: 2010 SEUC-accident victim-gone
    • CVO3: 2005 SEEG-traded on 2010
Re: SERK Engine Mount
« Reply #2 on: July 21, 2008, 10:29:41 PM »
It needs replaced.  If the vibrations aren't any worse than normal, I would ride until my dealer could get me in.  If I were going on a trip, I would replace before then.
Logged

Spike

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 331

    • CVO1: 05 vrscse-sold
    • CVO2: 07 flhrse
Re: SERK Engine Mount
« Reply #3 on: July 21, 2008, 11:46:45 PM »
I had a mount go bad on my SERK but I could only tell when it was idling and when the bike was running around 2500rpm's. Is the bike vibrating more than normal? It shouldn't take the dealer long to replace it.
Logged

Sean M Cary

  • Guest
Re: SERK Engine Mount
« Reply #4 on: July 22, 2008, 06:16:42 AM »
Quote from: Spike on July 21, 2008, 11:46:45 PM
I had a mount go bad on my SERK but I could only tell when it was idling and when the bike was running around 2500rpm's. Is the bike vibrating more than normal? It shouldn't take the dealer long to replace it.

I don't know what normal is...  Have only owned this since April - and put just over 1000 mi on it...  It doesn't seem to vibrate that bad, but maybe I just don't know?

Will get it replaced ASAP.

Thanks!

Sean
Logged

Spike

  • Senior CVO Member
  • ****
  • Offline Offline
  • Posts: 331

    • CVO1: 05 vrscse-sold
    • CVO2: 07 flhrse
Re: SERK Engine Mount
« Reply #5 on: July 22, 2008, 09:45:23 AM »
While I was riding and I got the rev's to 2500 rpm's, my floorboards would vibrate. Anywhere below or above and I never noticed it. At first I thought it might have been the crank runout issue that many here have experienced so I took it to the shop and they fixed the mount very quickly. Sorry I wasn't more specific earlier
Logged
 

Page created in 0.207 seconds with 20 queries.