Ok, I made my first attempt at installing the tp, yet, with negative results. Sblair, I drilled the holes as per moco's instructions, I went the extra mile and taped the bottom of the tp, so as to not scratch or damage the lovely paint. I placed the detachable rack onto the motorcycle, lined up the tp, and intalled the screws as per the Moco's instructions. However, the hex head screws provided do not fully go through the tp mounting plate, tp, and then the rack. It seems as if they are at least 1/4" to 1/2" too short. I read over the instructions again and again and I was following the directions right.
It's enough to drive me to
So, I will take my pack of hex heads, washers and locking nuts to the dealership and meet with a tech about it.
PS. My spoiler/wing with leds arrived today as well. But after reading the instructions, I'll leave that up to someone with some electrical knowledge.