Hi all, I just finished installing a reverse gear kit to my 08 CVO Ultra,
it was an easy install with very good instructions, the kit was from E glide, and made by Champion Trikes of California.
the whole job took me 3.5 hours and all seems to be ok, it will make my life sooo much easier !
I will up date as to any further information
UPDATE
I am still having computer probs, photo's will not down load, still this unit is mechanical,
you remove the clutch actuator,(mine is Hydraulic)remove the lock nuts from main and lay shafts,
install sprockets in there place, torque to 80 ft lb,drill and install dowell pins,then fit the unit which has
a third cog which when engaged meshes with the other two, thus driving your bike backwards,
this must ONLY be engaged in nutrel,re fit clutch actuator after fitting new push rod (approx .75 inch longer)
as this is the thickness of the unit,
To opperate start your motor, engage clutch, engage reverse lever by pushing down to clear gate,
ease backwars to engage gear, gentley ease out clutch with low revs and hey you are going backwards!!
I will post photo's when I sort this comp problem