Topic: Wire harness in Handle bars (Read 1454 times)

caymanjack · « **on:** September 29, 2005, 07:46:54 PM »

I want to put the wire harness that runs to both the right and left hand switch controls inside the handlebars. Has anyone done this before? If so how did you go about doing this? What size holes did you drill? Where?

naitram · « **Reply #1 on:** September 30, 2005, 08:36:24 AM »

are you changing your bars or just want to hide the wires in your existing bars?

caymanjack · « **Reply #2 on:** September 30, 2005, 09:29:20 PM »

I just want to hide the wires.

naitram · « **Reply #3 on:** September 30, 2005, 09:32:37 PM »

check out this article

http://www.bikernet.com/roadkingreport/roadkingreportarch.asp?Article=122002

more info then you will need but should give you some good pointers

caymanjack · « **Reply #4 on:** October 01, 2005, 04:57:09 PM »

Thank you that was very helpful. I just finished installing the wires in my handle bars. Not hard at all. Thanks again.

naitram · « **Reply #5 on:** October 02, 2005, 09:54:01 AM »

glad i could be of help

Author Topic: Wire harness in Handle bars (Read 1454 times)

caymanjack

Wire harness in Handle bars

naitram

Re: Wire harness in Handle bars

caymanjack

Re: Wire harness in Handle bars

naitram

Re: Wire harness in Handle bars

caymanjack

Re: Wire harness in Handle bars

naitram

Re: Wire harness in Handle bars