Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[CoalvilleBob]

I've got a little over 9,100 miles and it's been running great.  I had it detailed and now it's running like crap. 

I cleared the diag except I can't get rid of Pn 21836-09 & 31840-09.  I rode it maybe 10 miles and parked it.  I'm getting a P0151.  Its been 6 hours since it was detailed and it's been sitting in the sun.  I can't figure out what's wet or where but it was fine until the detail so either somethings loose or wet.  I doubt it just failled.

[Fired00d]

Just wondering do you have a Power Commander installed on your bike? I've heard/read of incidents w/them getting wet, but don't remember if they thru a fault code or not when this happened.

 
Ride Safe,
Fired00d
 

[CoalvilleBob]

No an I googled the error code; I just found it in the 09 Electrical manual an it says it's a Jiffy Stand Sensor.  That makes no sense.  I'm running on one cylinder until I rev it an then both kick in but intermittently.

[ice6900]

 i was at bisley last year, they had a demo bike rocker c, it would start n run ok, but as soon as u put it in gear and started to let the clutch out the engine would cut out, caused by a faulty Jiffy Stand Sensor.

[HDDOCFL]

I was getting the same code, found the problem , one of the wires was not setted in the plug to the main harness, pushed the wire back into its seat and pushed the two connectors together.  Had to unplug the 02 sensor and look inside the plug to see it.  Doc

[CoalvilleBob]

I found that the detailer had removed a plug wire to polish some chrome.  Got water in it and after blowing it out it's again running smooth.   I'll let the dealer figure out the Jiffy Stand Sensor.  I read about it in the manual but I've never seen it work by disabling the starter or showing on the odometer.

Thanks to all for a fast respose.  I guess Friday the 13th got me.