Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Eqcons]

My WO Chubby 575s have arrived!    They are the wong ones!  

These are without the notches for the throttle by wire.  I'd like to try to modify them to take the TBW, so does anyone have a set that they can give me a few dimensions off, please? (in mm if possible!!)  

I need to know:

· The length of the bar end from the "step", as I believe I need to cut ½" (?) off; currently that dimension is 185mm (just over 7¼").  

· The number of notches and their positions relative to one another

· The dimensions of each notch (are they all the same?)

· The rough position of them on the circumference - I'm told that this is not critical, so roughly is fine.

And of course, I need to know this stuff URGENTLY!

Thanks guys,

Jim

[Eqcons]

If anybody else has this problem, I now have the bars fitted and working.  You need to cut ¼" (note, NOT ½" which was what Wild1 Inc suggested to me, and what Flanders says - possibly correct for non-chubbies!)  off the end, and cut three slots in the end - you can mark up the locations with the TBW gizmo and measure the width depth of the slots off the old bars (actually two slots directly opposite each other 3/8" wide, and one slot 3/16" wide on top of the bars between the other two. All are 1/4" deep.) Exact position of the slots on the bars circumferentially is not important, as long as they are all the correct spacing apart.

Jim