Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: big radius 2-2, super tuner SE pro & dyno tune, opinions please  (Read 1233 times)

0 Members and 1 Guest are viewing this topic.

dlaws01

  • 1K CVO Member
  • *
  • Offline Offline
  • Posts: 1502
  • Rejoicing in hope, patient in tribulltion

    • CVO1: 105th Anniversary FXSTSSE2

I have a 2008 CVO springer and have just had vance & hines big radius 2-2 exhaust installed and the super tuner SE pro P/N 32109-08B and a dyno tune from the dealer, Bumpus H-D of Jackson, TN. The dynojet numbers are 104.97 torque and 81.34 horsepower.  Peak torque is between 3000-3500 rpm and peak hp from about 4500 to 5000 rpm.  I really don't know if this is good or bad.  Any opinions are appreciated.  One thing I noticed that I really wasn't expecting is that before the pipes & tune my oil temps usually stayed around 205 - 210 but now seem to hover around 225.  Do you think I'm good to go or should I be concerned?  Thanks
Logged
Jesus is Lord

Tabatha

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 108
Re: big radius 2-2, super tuner SE pro & dyno tune, opinions please
« Reply #1 on: August 19, 2010, 12:35:49 AM »

check out this thread (FXDF-SE Dyno run ... ) here in the intake/exhaust section ! Your dyno looks almost exactly like mine with the same mods ! Must be close to average !
............I have oil coolers , so can't relate to your cooling but mine runs about 250 degrees W/ twin oil coolers !
« Last Edit: August 19, 2010, 12:37:43 AM by Tabatha »
Logged
 

Page created in 0.243 seconds with 24 queries.