Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Wheelsnkeels]

While following several SESG bikes in Sturgis I felt they were a little boring from behind. So I started looking for ways to enhance the lighting.

So I bought some cool LED lights for the Bags, Now I am looking for a plug in harness to install them.

Each light is 3 wire a ground and the running circuit and a Brake / Turn circuit. They are 8.5" tall and 3" wide

I am told there is a connector for this function? anyone who can shed some light (no pun intended) on this it would be great  

[Harleypingman]

You could probably replicate the wiring harness and connectors, including those necessary to allow the saddlebags to be removed, using some of the parts included in HD's saddlebag spoiler LED accessory: 

http://www.harley-davidson.com/gma/gma_product.jsp?PRODUCT%3C%3Eprd_id=845524441837935&FOLDER%3C%3Efolder_id=2534374309041116&ASSORTMENT%3C%3East_id=2534374309041116&bmUID=1284076494930&bmLocale=en_US

Wiring it the way HD provides in that kit will provide run/brake function, but no turn signal function and it will use the accessory connector under the seat.  You can get the installation insturctions and parts list at the parts counter of your local HD store--they're not on HD's website.

When I installed the saddlebag spoiler LED's on my '04, I wired the LED's to the run/brake/turn signal module that HD offers that converts the rear turn signals to run/brake/turn signal function and that worked fine instead of using the accessory connector.  Of course, your rear wiring is different, but perhaps you can splice the appropriate wires in your rear light harness to provide the run/brake/turn signal functions using the some of the parts from the above kit for runing the wiring from the saddlebags to the rear light connector.

Good luck with your project.

Carl

 

[Wheelsnkeels]

That's a good option I found this at www.baggernation.com ordering tomorrow.
http://baggernation.com/products-lights.htm

Looks like it will do the trick?