Topic: cruse control rolloff switch clamp (Read 1878 times)

VRODDAVE · « **on:** September 30, 2010, 10:16:16 PM »

I am in the process of replacing throttle cables, and needed to remove the clamp on the neck of the frame, near where the cruse control roll off switch is located. its a philips screw ... came off fine, but apparently there is a rubber gromit with threads on it, that dropped inside the frame. how on earth did they get that thing inside the frame to begin with?

Has anyone ever retrived this part? or even had it happen? i had no idea it was there, else i would have done a better job hanging on to it ...

any advise?

MAT · « **Reply #1 on:** September 30, 2010, 10:47:33 PM »

Can you install a nutsert in the hole !

Cvostu · « **Reply #2 on:** September 30, 2010, 11:25:05 PM »

You will never find that again.. You can get it at the dealer or at most hardware stores like Ace or Home Depot.. Its called a "wellnut". Take the screw with you to match it up.. Thats what I did..... Twice..

VRODDAVE · « **Reply #3 on:** October 01, 2010, 09:18:02 AM »

Thank you for the advise

funny, I have run wires through the upper clamp, and the screw does not use "Wellnut". It just screwed into threaded frame.

Anyway, thanks for the heads up, wont waste any more time on retrevel.

Cvostu · « **Reply #4 on:** October 01, 2010, 09:13:43 PM »

I have a part number for that wellnut at home. I'll let you know shortly.

Cvostu · « **Reply #5 on:** October 03, 2010, 03:56:43 PM »

the partr# for the wellnut is #5207 washer is #6047 screw is #933

Author Topic: cruse control rolloff switch clamp (Read 1878 times)

VRODDAVE

cruse control rolloff switch clamp

MAT

Re: cruse control rolloff switch clamp

Cvostu

Re: cruse control rolloff switch clamp

VRODDAVE

Re: cruse control rolloff switch clamp

Cvostu

Re: cruse control rolloff switch clamp

Cvostu

Re: cruse control rolloff switch clamp