Well boys, I for one am curious if you set the tool up properly.....don't mean to make a fuss here but I am curious as merely a foundation to begin from.
Ummm did you put the indent set screw in at the back of the feuling plate, and did you properly "zero" out the dial indicator before doing the check? You may indeed know how to work this tool, so I am not trying to be offensive.
There are really no instructions that come with the tool or how to use it, I for one had to acquire some "specific" instruction from a "precision machinest" that was gracious enough to teach me how to use this "particular" tool, buttttttt lol perhaps you were/are much more familiar with the tool than when I received mine.
Fill me in on your procedure on how you used it if you don't mind.
.056" would "typically" result in a total catastrophic failure.
Regards,
Tim