Please login or register.

Login with username, password and session length
Advanced search  
Pages: 1 [2]  All

Author Topic: Pull Back Bars  (Read 6391 times)

0 Members and 1 Guest are viewing this topic.

DesertHOG

  • Visiting America One Road Trip at a Time
  • 2.5K CVO Member
  • **
  • Offline Offline
  • Posts: 3756
  • Vivid Black Special
    • NM


    • CVO1: 2011 FLTRUSE - SOLD
    • CVO2: 2015 FLTRUSE - SOLD
    • CVO3: 2018 FLTRXS - Vivid Black
    • Join me on Facebook
Re: Pull Back Bars
« Reply #15 on: January 03, 2011, 09:28:10 PM »

Was gonna say.. be careful to make sure they work. I just upgraded to the Yaffy OEM Monkey Bars for my FLTRUSE. It was an extremely tight fit according to the tech at my dealer. You have to take into account;

Fly by Wire
Heated Grips
Control Wiring
GPS Wiring and
Hydraulic Cabling can be a concern too.

Good Luck,
DesertHOG
Logged

Beemer

  • Elite CVO Member
  • *****
  • Offline Offline
  • Posts: 690
  • USAF CMSgt (Ret)

    • CVO1: 2009 FLTRSE3 Electric Orange/Vivid Black
    • CVO2: 2015 FLTRUSE Autumn Haze/Carbon Dust
Re: Pull Back Bars
« Reply #16 on: January 05, 2011, 12:01:46 PM »

If you ever pull the wiring out of the bars...for any reason, I suggest you cut off the original HD black/shiny wire sheathing and replace it with heat-shrink.  It is as strong if not more than the original and gives you all kinds extra of room to run either the stock HD heated grip wires or the Heat Demons. 
Logged
Pages: 1 [2]  All
 

Page created in 0.264 seconds with 25 queries.