Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: Power Commander 5 and 4" Rienharts...stalling when cold and flat spot  (Read 760 times)

0 Members and 1 Guest are viewing this topic.

Ranger

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 72

All

I have the Power Commander 5 and 4" Rienharts on my SERGU....  When it's cold it stalls and there is a flat spot in the throttle.....it also pops when I decelerate at 2200 to 1900 RPM<....  Taken it back to shop several times...can't seem to get it right....  Any suggestions..
Logged
2018 CVO StreetGlide

Twolanerider

  • 25K CVO Member
  • *****
  • Offline Offline
  • Posts: 50583
  • EBCM #1.5 Emeritus DSP # ? Critter Gawker #?
    • MO


    • CVO1: 2000 Triple Red Screamin' Eagle Road Glide
    • CVO2: 2002 Candy Brandywine Screamin' Eagle Road King
    • CVO3: 1999 Arresting Red FXR2
Re: Power Commander 5 and 4" Rienharts...stalling when cold and flat spot
« Reply #1 on: October 17, 2011, 11:56:46 AM »

All

I have the Power Commander 5 and 4" Rienharts on my SERGU....  When it's cold it stalls and there is a flat spot in the throttle.....it also pops when I decelerate at 2200 to 1900 RPM<....  Taken it back to shop several times...can't seem to get it right....  Any suggestions..

Did the problems start immediately after the installation of the exhaust and Power Commander (assuming they were done together)?

Do the problems go away or change significantly if you unhook the Power Commander?

Most likely wild ass guess starts with a bad tuning effort perhaps combined with an exhaust leak.
Logged

PASN YU

  • Ride Hard
  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 163

    • CVO1: 2012 FLHXSE3 Ruby Red/Typhoon Maroon
    • CVO2: 2019 FLTRXSE Mako Shark
Re: Power Commander 5 and 4" Rienharts...stalling when cold and flat spot
« Reply #2 on: October 17, 2011, 02:31:30 PM »

To remove the decel pop add a factor of 15 in the 0% throttle column to the rpm ranges you are having issues with.
Logged
Trust, but verify.

Ranger

  • Junior CVO Member
  • **
  • Offline Offline
  • Posts: 72
Re: Power Commander 5 and 4" Rienharts...stalling when cold and flat spot
« Reply #3 on: October 17, 2011, 04:26:14 PM »

Had problem once Power Commander was installed...
Logged
2018 CVO StreetGlide
 

Page created in 0.215 seconds with 20 queries.