Mine was replaced when it was in the shop for a replacement amp on my SESG. They replaced the switch but now the brakes are very soft. No modulation at all and the pedal almost goes all the way down before they start to brake. I took it back and they re-bled them but its doing the same thing. I'm taking it back tomorrow so they can try again. It may be something I have to get used to but it sure seems like they aren't getting all the air out. I know they used the digital tech both times so not sure what to do next if there are no changes.
Trust me, it's not something you should just get used to. They are doing something wrong, and they need to figure it out and do it right. It isn't just a case of hooking up the DT, they have to follow the procedure as detailed in the instructions and then verify the repair. And depending on how much air they let get into the system, it may take more than one attempt to get the air out. If they were reputable professionals, they would never give it back to you until it was done right and verified.
If they don't get it right, contact the MoCo and get them involved. This is a safety related recall, and if you have your recall notification letter you will find contact information for both H-D and the NHTSA and a request that you contact them if the dealer doesn't handle the recall satisfactorily. I suggest you do so.
Jerry