Have a 2012 CVO RG (maple and I love it) and installed fulsac header and baffles along with the TTS master tune with the map fom Steve but now the bike is harder to start -3 or 4 tries to get it going - would like to hit the key and go. Any ideas what could be the problem
You didn't accidently disable the automatic compression releases did you? While the map that is provided may not be 100% the best your particular bike can be, most who have done the "standard" Fullsac Stage I (X pipe and cores) have not had issues with how the bike runs. Could it be better? Maybe, but in some cases I have known, people have taken the bike to be dyno'd and the tuner has said that it's already so close, I don't really think I can do anything to improve it much. I would double check what map I loaded, then load it again, making sure I didn't accidently change something in the process. While I do not deny the fact that any given bike can be improved with a good individualized tune, I also do not subscribe to the school of thought that every single STOCK bike is so significantly different that they HAVE to be tuned to run properly. Otherwise, HD would have to load particular maps in each bike that came off the assembly liine, based on whatever parameters were "off". They don't do that.
If reloading the map doesn't work, I'd contact Steve at Fullsac and see if he can help solve the problem, or there are enough folks on here that have done exactly what you're doing, I'm sure you could get a copy of their map to see if it changes things. Mine runs perfectly with the canned map I was supplied, and I've got basically the same bike you do, other than some electronics and a Tour Pak.
Author
Topic: Hard to start after Tts and Fulsac mods (Read 1692 times)