UPDATED with pics and answers.
Hi guys/gals,
Got my tp quick detach hardware on. Hate the license plate location. I know there is a lot of info here about how to relocate it but nothing I have found that answers a couple specific questions I have about my 2011 CVO Ultra.
1. The rigidly mounted red reflector under the ts bar: Is it mounted with screws to the ts bar that would allow a stock kuryakin 3162 0r 3163 curved license plate frame to go on there? (Took it off prior to before pic.)
Yes it is mounted with 2 bolts that allow a curved license plate to mount there. I used Kuryakin part # 3163 from J&P (340-490) 72 bux with club membership.
2. Looks like whatever I use will cover up the CVO Emblem on the fender, true?
Yes it covers half of it, but I don't care. Looks good anyway.
Confirmed the light bar on the FLHTCUSE6 is same as 09 SG so removal of fixed red reflector also uncovered two mounting bosses with screw holes to fit license plate light assembly P/N 69353 05. (14 bux) from dealer. Also need qty(2) 6-32 x 5/16 (I used 3/8 and it worked.) screws for that plus a connector part number 73153-96BK 3 pin that plugs into the tail light housing in a socket there for the light. 2 black wires from light plug into pins 1 and 3 leaving middle one open. Looks like the whole tri-light assy is the same as the 09 SG.
All was accessible without taking of tire or fender, easy install. 2 bolts hold on the ts bar, wire guides are easy to get wire out of. Just had to remember to put wires into 3 pin connector AFTER it is routed into tail lamp since that one won't fit through the fender holes for turn bar wires. Almost screwed that up and put it on first.
Hope this is helpful for anyone else who wants to make this transition. Now going out to the garage to install Arlen Ness Slam Kit on rear shocks. Also got the Brukus bag locks and seat bolt. Looks like a piece of cake.
Sledge