www.CVOHARLEY.com

Please login or register.

Login with username, password and session length
Advanced search  

Author Topic: LEDs on saddle bag rails  (Read 697 times)

0 Members and 1 Guest are viewing this topic.

bikerdad

  • Newbie
  • *
  • Offline Offline
  • Posts: 31

    • CVO1: '11 FLRTUSE Frosted Ivory/Antique Gold
    • CVO2: 02 FLSTC Black w/ old school pinstripes
LEDs on saddle bag rails
« on: November 02, 2012, 06:41:14 PM »
Just finished installing the LED kit for the airwing rails on my saddle bags. they don't work (well, 1 did for a little while), and before you say it, wiring is ok. So, my question is, are they supposed to run on 5.7 - 6.5 volts? If not then i guess they are no good from out of the box. :confused5: checked volts at the connector that disconnects at the bag and where the split harness connects under the seat.
Logged
Fulsac X-pipe, V&H High Output slip-ons, SEPST, Progressive Mono Tubes / 944's & Wild 1 502's

Mr John DEUFF

  • Full CVO Member
  • ***
  • Offline Offline
  • Posts: 236

    • CVO1: FLHTCUSE2
Re: LEDs on saddle bag rails
« Reply #1 on: November 11, 2012, 03:01:30 PM »
I'm not an electrical specialist but IMHO they should need 12 volts to work.
Logged
 

Page created in 0.231 seconds with 24 queries.