Topic: CVO Breakout with Fullsac cores (Read 925 times)

Saljemar · « **on:** March 17, 2014, 10:53:39 AM »

Has anyone installed the 1.75" Fullsac cores into their CVO Breakout? If so, did you need to re-program? If you didn't re-program, were their any problems with performance or running too lean?

deldago · « **Reply #1 on:** March 17, 2014, 11:02:28 AM »

I ran the 2 inch cores in my Road glide, not a Breakout, for 6 months without a problem. No decal popping and plugs looked fine. I just installed his head pipe and tune and what a difference! Most of the heat is gone and the bike runs much better! Go the next step, you won't regret it.

grc · « **Reply #2 on:** March 17, 2014, 11:54:44 AM »

Quote from: Saljemar on March 17, 2014, 10:53:39 AM

Has anyone installed the 1.75" Fullsac cores into their CVO Breakout? If so, did you need to re-program? If you didn't re-program, were their any problems with performance or running too lean?

Check with the folks from Fullsac, but I think they only sell cores and pipes for Touring models, not Softails. Or I may be FOS, as usual.

Jerry

Author Topic: CVO Breakout with Fullsac cores (Read 925 times)

Saljemar

CVO Breakout with Fullsac cores

deldago

Re: CVO Breakout with Fullsac cores

grc

Re: CVO Breakout with Fullsac cores