Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Highwaystar]

I guess the little caution flag worked. It is very clear to every one now that you were fabricating a test set. Any chassis race car fab shop with a mandrel type bender can pop out a set easily. Nice job with the mock up FUZZ.

[FUZZNUTS]

Then your bars should be better in that if you want them closer, all you'd have to do is roll them back a bit. 

Have you found a fab shop yet?

I sent a email to Flanders out in California, and I got a responce back from them. Looks like I have to wait until the 24th to hear from Mr Flanders himself. I do have a local guy here but he's not a productin based outfit. I have lots of time to find someone. ................................................Fuzz 

[Texas 103]

Update..........................The 2011s handlebars are basically the same hieght but more pull back than the 09 SERG. I measured the 11s handle bars on the show room floor. And basically for hieght from the bottom 90 to the top 90 and it's 9 1/2 inches on the 11s bar. And the bars I modified from the same points measure 11 1/2". I have'nt got a chance to take a pic side by side with my bike because it's been at the dealers since last Wed. I thought that I was having issues with the compression relief but it turns out it's a starter problem. So hopefully I'll be getting the bike back  by Tues night. I gottta leave for Fayetteville W.V. Wed morn.............................................Fuzz

Get them to upgrade your comp Rich...Hard starting & kick back, they will warranty an S.E comp, they just can;t call it that..I will be nice and quiet....

[cmecatchu2]

Texas 103--

what do you mean by hard starting and kick back on the SERG?

[NVWLDTHG]

I can't believe I went to the other Road Glide blog to find pictures of the new bars.  And, then I got sidetracked looking at windshield pictures.

[FUZZNUTS]

Finally, got the new handlebars fabbed. They'll be chromed this week , installed next week. I'll post some of the pre chrome pics later on tonight. .........................Fuzz

[FUZZNUTS]

1st

[FUZZNUTS]

2nd

[FUZZNUTS]

3rd

[FUZZNUTS]

last, they'll be chromed this week and I should have them installed next week sometime.

[cmecatchu2]

Looks great, can't wait to see them installed and what you think. Who did the work for you?

[LETS_ROLL]

Looking good.  Let's Roll

[FUZZNUTS]

Looks great, can't wait to see them installed and what you think. Who did the work for you?

 


I don't have them in my hand yet. The bars are getting chromed as I speak. I have left my template with the vendor. If anyone wants to replicate them again, all they have to do is get a hold of this gentleman. Bill Rickards. I'll post his website. Once I get the new bars back in my hand I will take a couple of pics side by side with the OEM's and my new and improved and a couple of pics with the improved hand and arm position after installation. Then if anyone likes what they see, then you can put a order in with Bill. GH turned me on to this guy. He's located in New york State. It will be a week or two before I can get any more pics................................................................................Fuzz



 http://www.brcustomcycles.com/MEASURING_NEW_BARS_UP.php

[LETS_ROLL]

Can't wait that might be the ticket for a few of us here.  Let's Roll

[GregKhougaz]

Looks great Fuzz!  Looking forward to seeing the final version.